Description
* Old type fog lamps used in JB23 early model and JB33 cannot be used because the bulb standard is different.
* Please check the bulb standard of the installed fog lamp.
[TOTSUGEKI L1800 & L1500y Set contents]
・ LED fog valve x2
・Ballast x2
・ Hex wrench for adjustment x1
・ Double-sided tape for ballast fixing (3M)
・ Warranty (1 year warranty)
Features
[Comparison of power consumption and brightness]
・ TOTSUGEKI L1800 LED valve: 20W 1,800 lumens (
6000K )・ TOTSUGEKI L1500y LED valve: 20W 1,500 lumens (yellow)
・ JB23 genuine H8 halogen valve: 35W 400 lumens
・ JB43 genuine H11 halogen valve: 55W 700 lumens
The light-emitting part that can be changed vertically and horizontally
The light-emitting surface of the LED bulb can be changed vertically and horizontally with the attached hexagon wrench. You can choose the vertical direction, the horizontal direction, or the way the light spreads as you like. (It is necessary to remove the bulb from the fog lamp case to adjust the angle of the light-emitting surface.)
Installed from genuine Jimny to vehicles equipped with TS exterior kit without processing
LED bulbs with a long type heat sink at the rear, which can be seen in other products, are attached to the frame when vehicles are equipped with an Apio TS exterior kit etc. It interfered and could not be installed without processing. Therefore, the heat sink shape is specially designed, and it is a thin type that can be installed without processing without impairing heat dissipation efficiency.
* Please remove the bumper from the car body for installation work.
Heat sink that suppresses lens damage
By releasing heat from the heat sink, the aggression to the lens was reduced, and the lens surface temperature was suppressed to 30 ° C or less in a 30-minute test. Since the lens surface does not get hot, deterioration of the lens can be suppressed.
Conformity
The TOTSUGEKI fog valve series is for H8 valves (JB23 late) and H11 valves (JB43 late). Only the type with the left fog lamp shape can be used.
* It can also be used for fog lamps with squid rings used in Jimny JB23-9 type limited cars and JB43-8 type limited cars. This product cannot be used for the two Jimny fog lamp cases in the middle and on the right because the bulb specifications used are different.
Reviews
There are no reviews yet.